EXACTLY HOW DO I TURN OFF THE WATER MAIN SUPPLY TO MY HOME?

Exactly How Do I Turn Off the Water Main Supply to My Home?

Exactly How Do I Turn Off the Water Main Supply to My Home?

Blog Article

Book Your Service


Listed here down the page you can locate a lot of awesome insight involving How to Turn Off Water To House and Prevent Damage.


How to Turn off the Water for Plumbing Repairs
One of the most usual areas a water pipe will certainly be situated in residence remains in your boiler room, basement, or a cut out panel in a section for your home.
Once you find the water main you will just turn the valve clockwise to shut all the water off in your home up until you have completed the repair service. Some houses will certainly enjoy shutoff with a lever that you can pull rather than look to shut the water off.
If you try to shut the water off to your fixtures by using an angle stop and that doesn't work you will certainly need to close of the water pipe to make your repair service. There are additionally lots of other reasons you might need to close the water pipe like fixing icy pipes, repairing leaks, replacing fixtures or taps.
Many individuals are not mindful that they also have a water main valve right in their own house and also simply call a plumber of never wind up doing the repair work up until things get really bad because they merely do not know that shutting the water main is actually very easy.

How to Find and Shut Off Main Water Shutoff Valve


Where is the main water shutoff valve located?


This is the million-dollar question. Your main water shutoff valve could be located in several different areas. If you have a home with a basement and crawlspace, it is probably located on an interior wall near the front of the house, where the water comes in from the water meter. In this case, it is most likely hiding in plain sight. If your home was built on a slab, the valve might be located near the hot water heater or inside your garage.


How to Turn Off Main Water Valve


Once you find the shutoff valve you will either hand turn it (clockwise for gate valves and perpendicular to the pipe for ball valves) or use the appropriate tool depending on the design.


If it is located inside your house, it will most likely be a gate or “wheel” valve that you’ll simply turn clockwise to stop the flow of water. Another way to shut off the water is to go to the water meter box. Just be careful not to mess with the city shutoff side of the meter.


Where are the isolation valves?


Isolation shutoff valves are much easier to locate. Most essential home plumbing fixtures have separate valves that control the water flow. Sinks, toilets, water heaters, and washing machines should have a small valve located near the plumbing that can easily shut off the individual water supply.


Simply turning the valve clockwise will turn off the water flow. Sink and toilet problems can be dealt with quickly by simply shutting off the supply this way. It’s always good to test the isolation valves periodically to make sure they are working properly.



Again, once your tighten the water shutoff valves and turn off the water, open up your hot and cold lines to release pressure and test if the water is indeed off.



Make it a priority to locate the water valves in your home – and keep plumbing problems from turning into costly repair situations.

https://happyhiller.com/blog/how-to-find-shut-off-main-water-shutoff-valve/


How to Turn off the Water for Plumbing Repairs

We hope you liked our piece about How to Locate & Turn Off Main Water Shut-Off Valves. Thanks a lot for spending some time to read our content. Those who enjoyed reading our blog posting please don't forget to share it. Thanks for your time spent reading it.



Call

Report this page